The Airport 7 (Apt 7) Page - Honeywell BENDIX/KING KLN 94 Pilot's Manual

Chapter 3 Basic GPS Operation
6. Use the right inner and outer
knobs to complete line 4. The
F button must be pressed to
approve line 4 separately.
7. Turn the cursor off when you are
finished creating the remark (fig-
ure 3-159).
NOTE: If there are already 200 waypoints with remarks and an attempt is
made to enter a remark for a waypoint, a scratchpad message "Remarks
Full" is displayed. It is then necessary to delete remarks using the AUX
13 page before new remarks can be entered.
The Auxiliary 13 (AUX 13) page is a list of waypoints with associated
remarks. If you wish to delete a waypoint remark for an airport it is done
from the AUX 13 page, see section 5.11.

3.12.1.7. The Airport 7 (APT 7) Page

The APT 7 page shows the depar-
ture (DP) and arrival (STAR)
procedures that are available for the
selected airport. If both DP and
STAR procedures are available then
there will be two APT 7 pages indi-
cated by APT+7 (figure 3-160). If
there are no DP or STAR procedures
in the database then this page will be
as shown in figure 3-161.
NOTE: If the KLN 94 is configured
for VFR use only there will not be an
APT 7 page.
Line 1: The ICAO identifier (see section 2.3) of the airport; an arrow pre-
cedes the identifier if it is the active waypoint. "DP" is displayed for the list
of departure procedures and "STAR" is displayed for the list of arrival pro-
cedures.
Lines 2-5: List of the DPs or STARs. If there are more than four proce-
dures, the final one in the list is on line 5 on the screen. To view the
procedures that are not in view, turn on the cursor with the B button and
turn the right outer knob clockwise.
Figure 3-159
Figure 3-160
Figure 3-161
3-58