Honeywell BENDIX/KING KLN 94 Pilot's Manual page 150

Chapter 5 Intermediate Operation
When this is done, the pilot must verify that the proper course has
been selected by confirming the digital selected course readout dis-
played on the KLN 94. In the OBS mode the selected course is
always displayed on line 3 of the left side of the KLN 94 screen (in
place of DTK). In many installations, two or more navigation sources
can be displayed on one indicator. In these situations there is a switch
in the aircraft panel which will determine what navigation source is
displayed. For the KLN 94 to properly read the external indicator the
KLN 94 must be the displayed navigation source on the external indi-
cator.
4. There is no automatic leg sequencing or turn anticipation.
5. The Minimum En route Safe Altitude (ESA) displayed on the ALT 1
page is the highest MSA sector altitude between the present position
and the active waypoint. See section 5.1. for an explanation of ESA
and MSA. Other waypoints in the active flight plan do not affect the
ESA.
6. When the active waypoint is a VOR, and the AUTO magnetic variation
mode is active (see section 5.16), the published magnetic variation for
the VOR is utilized rather than the calculated magnetic variation, so
that the KLN 94 indication will be identical to a NAV receiver indica-
tion.
When the KLN 94 is not the displayed navigation source on the external
indicator, it is possible to change the selected course from the KLN 94
screen using the procedure below.
To change the selected course in OBS mode (not connected to
external CDI):
1. If the KLN 94 is not in OBS
mode, select OBS mode by
pressing the H button. The
cursor will automatically be
turned on over the OBS selected
course field (figure 5-43). If
already in OBS mode, turn on
the cursor(B).
2. Turn the right inner knob until the
correct selected course is dis-
played (figure 5-44).
3. Turn off the cursor (B).
Figure 5-43
Figure 5-44
5-16