Honeywell BENDIX/KING KLN 94 Pilot's Manual page 127

KLN 94 Pilot's Guide
ing GPS signals suitable for navigation. (Note: If the unit is in the
take-home mode, it has been "tricked" into thinking it is receiving
signals and therefore the symbol can be displayed). Also, the sym-
bol will not be displayed if Direct To navigation is occurring and the
Direct To waypoint is not in
FPL 0.
whether or not Direct To oper-
ation is occurring, view the
NAV 1 page. If the top line
shows the
4-29) instead of a "from" way-
point (figure 4-30), then Direct
To navigation is occurring. If it
is desired to cancel the Direct
To operation and operate from
the active flight plan, press
D, E, and then F.
• As flight plan waypoints are reached, the active leg symbol auto-
matically shifts to the next leg.
• If the flight plan contains more
waypoints than can be dis-
played on the screen at one
time, the page will automatical-
ly scroll as progress is made
along the flight plan so that the
active leg is always displayed
(figure 4-31).
• The last waypoint in the flight plan is always displayed at the bottom
of the FPL 0 page, even if all of the waypoints in the flight plan can't
be displayed on the page at one time. To view intermediate way-
points, turn the cursor on and use the right outer knob to manually
scroll through all of the way-
points, as desired. If scrolling
is performed all the way to the
end of the flight plan, a blank
waypoint position will exist so
that a waypoint may be added
to the end of the flight plan
(figure 4-32).
If in doubt as to
$
symbol (figure
Chapter 4 Flight Plan Operation
Figure 4-29
Figure 4-30
Figure 4-31
Figure 4-32
4-9