Dip Switch Settings; Table 6-1 Dip Switch S1 Settings; Table 6-2 Dip Switch S2 Settings - Honeywell VideoBloX User Manual

AUDIO INPUT MODULE

DIP SWITCH SETTINGS

Rev 1.0
Set the Audio Input Module DIP switches as follows:
Table 6-1
DIP Switch
S1
1
2
3
4
5
6
7
8
• S1 (1-8) sets the module address. This must be non-zero. A value of 1 addresses the
card to accept audio inputs 1 to 16, etc.
Table 6-2
DIP Switch
S2
1 Off = Output 1-64 / On = Output 65-128
2 Off = Normal / On = Review/Stereo
3 Off = Normal / On = Route 1 to 1
4 Off = Normal / On = Test Mode
• S2 (1) Turn on to associate the module with output channels 65 to 128.
• S2/2 Turn on to cause the module to work transparently as a slave to another input
module. This mode allows two cards to work synchronously for switching stereo
signals.
• S2/3 Turn on to cause the module to automatically switch its 16 audio inputs to 16
audio outputs on power up. In this mode, the address switch determines which group
of outputs will be used.
• S2/4 Turn on to cause the module to enter test mode. In this mode, the module
rapidly cycles various inputs to outputs. This is useful for bench-top faultfinding and
should not normally be used in the field.
DIP Switch S1 Settings
Function
A0 Board Address
A1 Board Address
A2 Board Address
A3 Board Address
A4 Board Address
A5 Board Address
A6 Board Address
A7 Board Address
DIP Switch S2 Settings
Function
38 900.0855
10/06