Table 3-5 Hvb16M32 And Hvb16M64 Dip Switch Sw2 Settings; Table 3-6 Hvb16M32 And Hvb16M64 Dip Switch Sw3 Settings - Honeywell VideoBloX User Manual

VIDEO INPUT MODULES
Rev 1.0
Table 3-5 HVB16M32 and HVB16M64 DIP Switch SW2 Settings
Switch Function
SW2.1 A8
SW2.2 A9
SW2.3 A10
SW2.4 B0
SW2.5 B1
SW2.6 B2
SW2.7 B3
SW2.8 B4
Table 3-6 HVB16M32 and HVB16M64 DIP Switch SW3 Settings
Switch Function
SW3.1 P0
SW3.2 P1
SW3.3 ON = FUNCTION A
ON = FUNCTION B
SW3.4
ON = FUNCTION B
SW3.5
SW3.6 ON = Switch 1 to 1
SW3.7 ON = Test Mode
SW3.8 No Function
• DIP Switches S1 (1-8) and S2 (1-3) define the card's address in a binary format and is
set to represent the camera range. For cameras 1-16 set the address to 1, cameras
17-32 set to 2, etc.
• DIP Switch S2 (4-8) sets the monitor group in binary format. Example: all off = card is
in a chassis for monitors 1-64. S2, 4 on = card is in a chassis for monitors 65-128.
• DIP Switch S3 (1-2) not used, set to off.
• DIP Switch S3 (3-5) Only switch 3 has been implemented. When switch 3 is on will
mute reply's back to the CPU. Used for systems that have 2 or more input cards with
the same address (e.g. systems with more than 64 outputs)
• S3 (6) is used for testing to switch 16 cameras to the outputs. If the address is 1,
cameras 1-16 will be switched to monitors 1-16. If the address is 2, cameras 1-16 will
be switched to monitors 17-32, etc.
• S3 (7) is a test mode that will randomly switch cameras to monitors. Used by
manufacturing.
• S3 (8) is not used.
Input Address
Output Address
Protocol
24 900.0855
10/06