INSTALLING A MODULE IN A VIDEOBLOX CHASSIS
Rev 1.0
Figure 1-4
Removing a Module from the VideoBloX Chassis
Perform the following procedure to insert a module in a VideoBloX Chassis.
WARNING!
If installing a CPU or combo CPU module, ensure the power
is off. Once installed, connect power.
1.
Align the module with both sets of rails located on the sides of the chassis. The card
requires minimal force to seat the connectors.
2.
Once seated, the card's power LED lights.
3.
Insert and tighten the two 3mm Phillips screws on each end of the module.
VideoBloX Chassis Only User Manual
5
900.0855
10/06