Removing A Module From A Videoblox Chassis; Figure 1-3 Location Of Phillips Screw And Pulling Tool - Honeywell VideoBloX User Manual

INTRODUCTION

REMOVING A MODULE FROM A VIDEOBLOX CHASSIS

2 x 3mm Phillips Screw
(removed)
Rev 1.0
The VideoBloX chassis incorporates the following components:
• Backplane: The backplane provides for distribution of power and control signals as
well as 64 audio or video (or mixed) signals. The distance between modules is 1/2U.
• Cooling System: VideoBloX is equipped with fans, which provide forced cooling to
ensure reliable operation for a fully populated chassis in ambient temperatures up to
104 degrees fahrenheit (40 degrees Celsius). Highly efficient, switch mode power
supplies are used throughout, which minimizes the power dissipated internally.
• Termination card mounting slots: Located on the rear of the VideoBloX chassis
allowing for different style termination cards to be fitted.
• Module mounting slots: Located on the front of the VideoBloX chassis allowing for
insertion of the full range of VideoBloX modules, except the power supply unit.
• Power supply slot: Allowing for insertion of the power supply module accessible from
the front of the VideoBloX chassis.
The modules are removed from the front of the VideoBloX chassis. Perform the following
procedure to remove a module from the VideoBloX chassis.
WARNING! If removing the power supply module, remove power to the
unit. All other cards are hot swappable.
1. Remove the two 3mm Phillips screws on the ends of the module to be removed.
2. Thread the two pulling tools into the inner threaded holes on the module to be
removed.
Figure 1-3 Location of Phillips Screw and Pulling Tool
3. Pull the module using both hands with thumbs as leverage.
2 x Pulling Tool
4 900.0855
10/06