Removing The Snowblower - Honda H2013 Operator's Manual

Removing the Snowblower

Removing the Snowblower
1.
Make sure the PTO clutch lever is OFF.
Drive the lawn tractor to a flat, level surface, turn the engine off, remove the ignition key and set the
2.
parking brake ON. Disconnect the spark plug cap. Lower the height adjustment lever all the way down.
3. Raise the front tires and support them squarely on top of two 4 x 4" blocks of wood.
4.
Remove the silver-colored bolt that holds the
engine pulley belt guard to the right side of the
lawn tractor frame. Allow the belt guard to fall
down slightly, then remove the snowblower
drive belt from the engine pulley.
5. Loosen the jam nut on the belt tension
turnbuckle, then lengthen the turnbuckle
enough to disconnect the J-bolt from the PTO
pivot plate.
6. Remove the 2 x 40 mm spring clip and two flat
washers from the PTO connecting rod where it
is connected to the PTO pivot plate. Allow the
rod to fall clear from the pivot plate. Retain the
spring clip and washers when reinstalling the
snowblower or the mower deck.
30
DRIVE BELT
BELT GUARD
FRONT
LOOSEN JAM NUT
REMOVE HOOK BOLT
FLAT WASHER
(2)
and
2x26mm
SPRING CLIP
SB2040 Snowblower
SILVER
PIVOT PLATE ON
U-SHAPED BRACKET
POP
52152 (9610)