Installing The Snowblower - Honda H2013 Operator's Manual

Assembly and Installation
Skid Shoe Installation
1. Insert one 5/16 x 1" carriage bolt into the lower
hole of each skid shoe. Loosely attach a 5/16"
lock washer and 5/16" hex nut.
2. Slip the carriage bolt head into the keyhole
opening in the lower, rear outside corner of the
blower head.
3. Install the other 5/16 x 1" carriage bolt, lock
washer and hex nut as shown. Tighten both hex
bolts securely.
4. Repeat for the other skid shoe on the other side
of the blower head.
5. The holes in the skid shoes are slotted so the
skid shoes may be adjusted. See the Operation
chapter for details on adjusting the skid shoes.

Installing the Snowblower

Remove the Mower Deck
Follow the procedure in the H2013 Owner's Manual or H20133 Shop Manual, and remove the mower deck
and front links from the lawn tractor.
Remove Optional Trailer Hitch and / or Grass Bag Supports:
Remove the trailer hitch and/or the grass bag supports if either are installed on the lawn tractor
The counterweight bracket cannot be installed with the trailer hitch or grass bag supports.
Raise and Support the Lawn Tractor
1. Raise the front end of the lawn tractor, and then
support it by placing a 4 x 4" board under each
front tire.
2. Engage the parking brake, remove the ignition
key, and disconnect the spark plug cap.
14
SB2040 Snowblower
5/16" CARRIAGE BOLT (2)
5/16" HEX NUT (2)
/16" LOCK WASHER (2)
POP 521 52 (961 0)