Maintenance & Adjustments; Maintenance Schedule; Adjustments - Honda H2013 Operator's Manual

Maintenance & Adjustments
Maintenance & Adjustments

Maintenance Schedule

Apply grease to antifriction ring
Apply grease to bushings
Apply grease to worm gear
Inspect and adjust PTO spring tension

Adjustments

For best possible performance, the SB2040 features a number of adjustments:
Skid Shoes
The skid shoes should be adjusted based on the
type of ground surface. For level, paved surfaces,
adjust the skid shoes to permit 5.0 - 6.5 mm
-
(3/16 1/4 inch) of clearance between the bottom
edge of the blower head and the ground. For
uneven or gravel surfaces, set the clearance to
13.0 - 16.0 mm (1/2 - 5/8 inch).
To adjust the skid shoe position, loosen (don't
remove) the two hex nuts on the skid shoe, position
the shoe as needed, then tighten the hex nuts.
Recheck the measurement and repeat if necessary.
34
When
Notes
two
Every hours use chainsaw oil
As needed
use general purpose grease
As needed
use general purpose grease
As needed
use general purpose grease
Each use adjust tension if needed
You can be seriously injured by the fan or
auger blades.
The blades spin and can cut or amputate your
hand or fingers.
Always stop the engine, remove the ignition
key, set the parking brake ON, and disconnect
the spark plug cap before attempting any
maintenance or adjustments.
SB2040 Snowblower
5/16'' HEX NUT (2
16" LOCK WASHER (2)
POP 52152 (9610)