Honda H2013 Operator's Manual page 38

SB2040 Snowblower
Install the New Belt
1. Installation is the reverse of removal. Refer to the illustration here to make sure the new belt is
properly oriented along all pulleys.
2. Make sure the belt guards are
correctly positioned as shown.
Tighten the center bolt on each
pulley to 27 - 31 N'm
(20 - 23 ft.-lb.).
There should be a 3 -5 mm
(1/8 - 3/16") gap [A] between each
guard and pulley.
Belt Tension Adjustment
i
1. Adjust the belt tension as described
on page 19.
POP 521 52 (961 0)
ENGINE CRANKSHAFT PULLEY
TWIST IN BELT ON
RIGHT SIDE PULLE
FIXED (LEFT SIDE) PULLEY
-
20 23
(27 31
Maintenance & Adjustments
RIGHT SIDE
REARVIEW
ft-lb.
MOVEABLE (RIGHT SIDE) PULLEY
PTO OFF
37