Headset Connections With The Callmaster V - Lucent Technologies CALLMASTER User Manual

CALLMASTER® V Telephone Console User's Guide 555-233-735
The CALLMASTER V Telephone Console
The following features correspond to the numbers in Figure 1.
1) Telephone Notepad
2) Mute (or
3) Speaker (or
4) Transfer/Test (or
5) Redial (or
6) Conf/Ring (or
7) Dial pad
Note: Two feature buttons must be administered in the following ways:
• One of the feature buttons must be designated as the
Headset On/Off button;
• The Release feature must be administered on a second feature
button.

Headset Connections with the CALLMASTER V

The headset connection for the CALLMASTER V consists of a headpiece
(shown as 1 in Figure 2 below) which is plugged into an adapter cord (shown
as 2).
Note: Your system manager MUST administer a
set. Use this button to turn your headset on and off. For instructions for
using this feature button, see "Headset On/Off" in the section titled
Call-Handling Features.
FIGURE 2 The Headset Connected to One of the Headset Jacks (shown
as 3) on the CALLMASTER V Telephone
) button
) button
) button
) button
) button
8) Volume control button
9) Display
10) Softkeys
11) Display control buttons
12) Hold (or
13) Call appearance/feature buttons
(See Note immediately below)
14) Message light — labeled
Headset On/Off
2
3
) button
button on your
1
Issue 1
2