What Is Zsim; System Requirements; Loading Zsim On The Printer; Loading Zsim With A Compactflash Card - Intermec EasyCoder PD41 Programmer's Manual

What is ZSim?

ZSim is a Zebra™ interpreter program that interprets legacy ZPL
II or later programs on an Intermec EasyCoder PF2i, PF4i, PF4i
Compact Industrial, PM4i, PX4i, PX6i , PD41, PD42, or PB50
Mobile Label printer with Fingerprint. To use ZSim, you need to
load the ZSim program into the printer, configure a few settings,
and start sending Zebra commands. If the ZSim program was not
factory-installed, you can find it on the PrinterCompanion CD
or you can download it from the Intermec web site.

System Requirements

The printer must be equipped with a minimum of 8 MB of
DRAM.
Hardware and Firmware Requirements
Printer Models
EasyCoder
PF2i, PF4i, PF4ci
PM4i
PX4i, PX6i
EasyCoder PD41
EasyCoder PD42
PB50

Loading ZSim on the Printer

Depending on your printer model, you can load ZSim on the
printer using one of these methods:
• CompactFlash card (all EasyCoder printers)
• Intermec FieldInstaller (PB50 mobile printer)

Loading ZSim With a CompactFlash Card

You can load ZSim on the supported EasyCoder printers by
using a CompactFlash card. The card must meet these
requirements:
• Have at least 128 MB of available free space
• Be formatted with FAT or FAT 16, but not FAT 32
ZSim Programmer's Guide
Fingerprint Version ZSim Version
8.70.1 or later
10.0.0 or later
10.2.1 or later
11.1.1 or later
5.14 or earlier
5.14 or earlier
5.15 or later
5.14 or later
11