Making A Recording; Making An Audio Or A Video Recording; Record Monitor; Making A Digital Recording - Pioneer VSX-D710S Operating Instructions Manual

Making an Audio or a Video
Recording
The following steps show you how to make an audio or
a video recording from the built in tuner, or from an
audio or video source connected to the receiver (such as
a CD player or TV) Recordings can be made to a CD-
Recorder, cassette deck, MD, VCR, or DVR deck
connected to the CD-R/TAPE/MD, VCR or DVR in/out
connectors
MONITOR
7
1 Turn the
MULTI JOG
dial to select a source to
record (you can also use the MULTI
CONTROL
buttons if the DIRECT FUNCTION
is on)
All functions except MONITOR are accessible from
the remote control
2 Prepare the program source
Tune to the radio station, load the CD, etc For a
video recording load the video, DVD etc
3 Insert a blank tape, MD, video etc into the
recording device connected to either CD-R/
MD/TAPE or VCRIDVR and set the recording
levels
Refer to the instructions that came with the recorder
if you are unsure how to do this Most video record-
ers set the audio recording level automatically-
check your video's instruction manual if you are
unsure whether yours has manual controls
4 Start recording, then start playback of the
source component
MEMO:
The receiver's volume, tone control (bass & treble)
loudness, and surround effects have no effect on the
recorded signal
You can listen to (monitor) the recording as it's being
made using the
MONITOR
button on the front panel (a
cassette deck would have to have a record monitor
function)
Press the
MONITOR
button to switch between the
recorded signal and the original source signal
Making a Digital Recording
The VSX-D710S has one optical digital output jack The
VSX-D810S/D850S has one coaxial digital output jack
and one optical digital output jack The quality of these
two types of connections is the same so you only need to
match the type of connection on this receiver with the
type of connection on your component If you want to
make a digital recording from this receiver hook up the
optical output on this receiver to the optical input on the
digital component you want to record into The source
component (like MD, CD, DVD, etc ) must be digital
also, of course, and hooked up to this receiver in a
digital manner Make sure the analog/digital switch is set
to digital (see p 29) The recording procedure is the
same as described above
Refer to the table below for the type of digital connec-
tions available in each receiver model
34
En