Pioneer VSX-D710S Operating Instructions Manual page 18

Preparations
SUBWOOFER ON/PLUS/OFF setting
mode
LFE attenuator setting mode
Sets whether the SUBWOOFER is used or not Also, when
used you have the option to use the
"PLUS"
setting
Dolby Digital and DTS audio sources include ultra-low
bass tones Set the LFE attenuator as needed to prevent
the ultra-low bass tones from distorting the sound from
the speakers
Press A or V to select subwoofer ON, PLUS
or OFE
MEMO:
l
The initial setting is
"ON"
l
Setting the front speaker size to "Small" in the
SPEAKERS setting mode automatically locks the
subwoofer in the
"ON"
position
l
Use the PLUS for extra bass When you use
PLUS
you will get the bass sounds from the subwoofer
even if the front speakers are set to "Large"
l
If you select
"OFF"
in this setting you won't be able to
select subwoofer in the surround back speaker
setting above
Press A or V to set the attenuation level (0
dB, 10 dB or ** dB(w))
c
0 dB e-,10 dB
OQ (display "G+ ~'7 3
MEMO:
l
The initial setting is "0
d6"
l
When 00 is selected (* * appears in the display), LFE
is not available
low cut filter ON/OFF setting mode
Turn the low cut filter
ON
when distorted sound is
output through the subwoofer
Crossover frequency setting mode
Crossover frequency is the point where the receiver
divides the high and low sounds (the frequencies)
between the speakers Since most smaller speakers can't
handle deep bass tones, this setting allows you to send
those sounds to the subwoofer (or speakers set to
"Large" if you don't have a subwoofer) instead of the
speakers set to "Small" in your system Choose the point
at which you want the frequency routed to the
subwoofer (or "Large" speakers)
We recommend setting this to 200 Hz if smaller
bookshelf-type speakers are used for your "Small"
speakers
Press A or V to select low cut filter ON or
OFE
MEMO:
l
The initial setting is
"OFF"
l
If the SUBWOOFER is set to
"OFF"
in the
SUBWOOFER ON/OFF setting mode, the low cut
filter cannot be set
FRONT speakers distance setting mode
Sets the distance from the FRONT speakers to the
listening position
Press A or V to specify the crossover
Press A or V to set the distance of the
frequency for your small speakers (100 Hz,
FRONT speakers from the main listening
150 Hz or 200 Hz)
position (within a 30 foot range)
,+ 100~2+-+~~Hz,
100 Hz
Sends bass frequencies below 100 Hz to the subwoofer
(or "Large" speakers)
150 Hz
MEMO:
l
The initial setting is 10 ft
l
One step equals about lft
CENTER speaker distance setting mode
Sends bass frequencies below 150 Hz to the subwoofer
(or "Large" speakers)
200
Hz
Sets the distance from the CENTER speakers to the
listening position
Sends bass frequencies below 200 Hz to the subwoofer
(or "Large" speakers)
Press A or V to set the distance of the
CENTER speaker from the main listening
position (within a 30 foot range)
18
En
MEMO:
l
The initial setting is
"100 Hz"
l
If all speakers (front, center, and surround) are set to
"Large" in SPEAKERS setting mode, crossover
frequency cannot be set because there are no "Small"
speakers (* * * appears in the display)
MEMO:
l
The initial setting is 10 ft
l
When "C * " is selected in SPEAKERS setting mode,
the Center distance cannot be set
l
One step equals about 1 ft