Pioneer VSX-D710S Operating Instructions Manual page 25

Displays & Controls
@ 00 /DTS button (see pages 27,29)
Use to put receiver in DOLBY DIGITAL, DOLBY
SURROUND and DTS modes
DSP button (see pages 28,30)
Use to put receiver in one of the DSP modes
TEST TONE button (see page 21)
Use to sound the TEST TONE when setting up the
surround sound of the receiver (the 00 /DTS mode
must be on)
SIGNAL SELECT (see page 29)
Use to select the proper signal (analog, digital) for the
source your are inputting On the VSX-D810S &
VSX-D850S receivers there is an AUTO setting In
this setting the receiver will automatically switch
between the analog and digital signals according to
what is being input If both signals are input the
AUTO setting will choose the digital one This setting
is convenient as the receiver will always choose the
best or appropriate signal
0 CH SELECT button (see page 21)
Use to select a speaker when setting up the surround
sound of the receiver To use first press the
RCV
button then operate this button
CH LEVEL +/- (see page 21)
Use to set up the levels of the surround sound of the
receiver To use first press the
RCV
button then
operate this button
FUNCTION button
Use to select the playback or recording source This
button lets you cycle through the different functions
of the receiver in the following order CD, TUNER,
AUX, CDR/TAPE, VCPJDVR, DVD/LD, DVD 7 1 Ch,
VIDEO, and TV/SAT (VSX-DSlOS/DSSOS)
CD, TUNER, AUX, CDRITAPE, VCR/DVR, DVD/LD,
VIDEO, and TV/SAT (VSX-D710S)
@ LOUDNESS button
Use to switch on the loudness This feature is useful
for getting good bass and treble sounds listening at
low volumes
FL DIMMER button
Use this button to make the fluorescent display (FL)
dimmer or brighter There are three brightness
settings as well as an off setting
SETUP button (see page 3540)
Use this button when setting up the remote control to
control other components
MUTING button
Use to mute the sound or restore the sound if it has
been muted
@ THE FOLLOWING BUTTONS ARE DEDICATED
TV CONTROL THEY ARE ONLY USED FOR
CONTROLLING YOUR TV
TV FUNC button
Use select the TV function
TV 0 button
Use to turn on/off the power of the TV
TV VOLUME +/- buttons
Use to adjust the volume on your TV
@ MENU button
Use to access different menus associated with your
DVD player
0 MASTER VOLUME +/-buttons
Use to set the overall listening volume
@ CHANNEL +/-buttons
Use to select the stations of memorized radio
frequencies Also use to skip tracks backward or
forward on CDs, DVDs, etc
@ a
D A V
( TUNE/ST +/-) & ENTER buttons (see
pages 16-21)
Use these arrow buttons when setting up your
surround sound system (see pages 16-2 1) These
buttons are also used to control DVD menus/options
and for deck 1 of a double cassette deck player The
TUNE/ST +/- buttons can be used to find radio
frequencies and preset stations, respectively
@ DISC (ENTER) button
Use to select a disc an in multi-CD player To use
first press the
RCV
button then operate this button
@I RECEIVER c> (POWER) button
This switches between STANDBY mode and power
ON for this receiver
@ LED DISPLAY (see pages 35-40)
This display flashes when a command is sent from
the remote control to the receiver It also flashes at
other times, for example when teaching the receiver
preset codes, with specific meanings
25
En