Connecting Digital Components; Connecting Audio Components - Pioneer VSX-D710S Operating Instructions Manual

Connecting Your Equipment
Connecting Audio Components
To begin set up, connect your audio components to the jacks as shown below These are all analog connections and
your analog audio components (like a cassette deck) use these jacks Remember that for components you want to
record with you need to hook up four plugs (a set of stereo ins and a set of stereo outs), but for components that only
play you only need to hook up one set of stereo plugs (two plugs) To use digital source features you must hook up
your digital components to the digital inputs (see the previous page for more on digital connections) but it is also a
good idea to hook up your digital components to these analog audio jacks If you want to record to/from digital
components (like an MD) to/from analog components, you must hook up your digital equipment with these analog
connections
When connecting your equipment, always make sure the power is turned off and the power cord is disconnected
from the wall outlet
The arrows indicate the direction of the audio signal
/ \
VSX-D7 1 OS
VSX-D81 OS/D8505
Cassette deck placement
Depending on where the cassette
deck is placed, noise may occur
during playback of your cassette
deck which is caused by leakage
flux from the transformer in the
receiver If you experience noise,
move the cassette deck farther
away from the receiver
8
En