Using The Tuner; Finding A Station; Tuning Directly To A Station - Pioneer VSX-D710S Operating Instructions Manual

Finding a Station
The following steps show you how to tune in to FM and
AM radio broadcasts using the automatic (search) and
manual (step) tuning functions If you already know the
exact frequency of the station you want to listen to, see
Tuning Directly to a Station on this page Once you are
tuned to a station you can memorize the frequency for
recall later-see Memorizing Stations on page 33 for
more on how to do this
MPX -
2-
-I
-3
1 Press the
MULTI CONTROL TUN
button on
the remote control.
On the receiver, use the
MULTI JOG
to select the
tuner mode
2 Use the
BAND
button to change the band
(FM or AM), if necessary
Each press switches the band between FM and AM
On the receiver, pressing the
BAND
button switches
between bands
3 Tune to a station
Automatic tuning
To search for stations in the currently selected band,
press and hold either the
TUNE +
or
TUNE
-button
for about a second The receiver will start searching
for the next station, stopping when it has found one
Repeat this step to search for other stations
Manual tuning
To change the frequency one step at a time, press the
TUNE +
or
TUNE
- (AV) buttons
High speed tuning
Press and hold the
TUNE +
or
TUNE
- button for
high speed tuning, releasing the button once the
desired frequency is reached
MPX mode
If the
TUNED
or
STEREO
indicators don't light when
tuning to an FM station because the signal is weak, press
the
MPX
button to switch the receiver into mono
reception mode This should improve the sound quality
and allow you to enjoy the broadcast
Tuning Directly to a Station
Sometimes, you'll already know the frequency of the
station you want to listen to In this case, you can simply
enter the frequency directly using the number buttons
on the remote control (this function is not available
using the front panel controls of the receiver)
2-
1 Press the
MULTI CONTROLTUN
button on
the remote control
On the receiver, use the
MULTI JOG
to select the
tuner mode
2
Press the
BAND
button to select either FM
or AM
Each press switches the band between FM and AM
On the receiver, pressing the
BAND
button switches
between bands
3
Press
D ACCESS (DIRECT ACCESS)
4 Use the number buttons to enter the
frequency of the radio station
Example To tune to 106 00 (FM), press
1
- 0 - 6 -
o-o
32
En
MEMO:
l
If you make a mistake while inputting the frequency,
press the
D ACCESS
button twice to cancel the
frequency and start again