SMART Board 685ix Configuration And User's Manual page 6

iv | IN T RO D UC T IO N – IMP O RT AN T IN F O RMA TI O N
• If the lamp has shattered or burst:
– Call an authorized SMART reseller
replace the lamp.
– Do not touch the glass fragments because they can cause injury.
– Leave and then ventilate the area where the lamp shattered or burst.
Wash your hands thoroughly if you have come into contact with 
–
lamp debris.
– Thoroughly clean the area around the projector, and discard any edible
items placed in that area because they could be contaminated.
• Replacing the lamp in a wall-mounted projector can result in a fall or injury.
Use caution when climbing a ladder, or remove the projector from the wall-
mounting bracket to replace the lamp.
– Uncovering the lamp while the projector is mounted on the wall-mounting
bracket can lead to product damage or personal injury from falling pieces
of glass if the lamp is broken.
• When replacing the projector lamp:
Turn off the projector and wait 30 minutes for the lamp to cool 
–
completely (or before removing the projector from the wall-mounting
bracket, if necessary).
– Do not remove any screws other than those specified in the lamp
replacement instructions.
– Wear protective eyewear while changing the lamp. Failure to do so can
cause injury or loss of eyesight if the lamp shatters or bursts.
– Use only replacement lamps approved by SMART Technologies. Contact
your authorized SMART reseller
– Never replace the lamp assembly with a previously-used lamp assembly.
– To prevent premature lamp failure or exposure to mercury, always handle
the fragile lamp assembly with care. Use gloves when touching the lamp.
Do not touch the lamp with your fingers.
– Recycle or dispose of the lamp as hazardous waste, in accordance with
local regulations.
• When returning the projector to the wall-mounting bracket, replace all of the
screws you removed when you removed the projector. Failure to do so 
can result in the projector falling from the boom resulting in injury or
equipment damage.
Part No. 99-00984-20 REV A0
for instructions. Do not attempt to
for replacement parts.