SMART Board Board 600i5 Configuration And User's Manual page 89

A P P E N D I X B
Disabling user USB access
g
To remove the USB jumper switch
1. Locate the USB jumper behind the jumper cover port.
2. Using needle-nose pliers, pull the jumper from the two connection posts, and then place it on a
single post.
I
I M P O R T A N T
Do not discard the jumper. Discarding the jumper makes the USB deactivation difficult to
reverse.
3. Insert the USB jumper cover into the USB A port on the front of the ECP.
4. Connect all cables to the ECP. See the Using the Extended Control Panel (ECP) on page 23
for more information.
5. Secure the ECP to your interactive whiteboard with the two screws you removed previously.
6. Connect the projector's power cable to the power outlet.
79