Adjustments - Honda HARMONY H1011R Owner's Manual

MAINTENANCE & ADJUSTMENTS
Adjustment
1.
2.
3.
4.
From the left side of the riding mower, locate the link adjust
plate on the mower deck near the left front wheel. This plate
is used to adjust the height of the left side of the mower
deck.
Loosen the two plate locking
nuts enough so the plate
can move. To lower the
left side of the mower
deck, tap the plate
LOCKING NUTS
forward toward the front of
the riding mower.
ADJUSTMENT PLATE
To raise the left side of the mower deck, tap the plate
rearward, toward the rear of the riding mower.
Once the left and right blade heights are within specification,
carefully tighten the plate locking nuts and then verify the
measurements again.
Front to Rear Mower Deck Adjustment
Inspection
1.
2.
3.
4.
5.
6.
Prepare the riding mower as previously outlined.
Set the mower deck height adjustment lever to the number
2 position.
Put on heavy gloves, as you need to rotate the blade.
Rotate the blade so it is
perpendicular to the front
axle.
Using a blade height
measuring tool, measure
the height of the cutting
edge of the blade to the
ground, from the front and
rear tips of the blade.
The rear tip of the blade should be 6 - 9 mm (l/4 - 3/8 inch)
higher than the front. For mulching, the blade can be set
level or 6 mm (l/4") higher in front.
If the rear is not within this specification, you'll need to perform
the front to rear mower deck adjustment.
77