Fuse Replacement (Electric Start Model) - Honda HARMONY H1011R Owner's Manual

The battery gives off explosive hydro-
gen gas during normal operation.
A spark or flame can cause the battery
to explode with enough force to kill or
seriously hurt you.
Wear protective clothing and a face
shield, or have a skilled mechanic do
the battery maintenance.
Charging the Battery
1. Remove the battery cell caps.
2. Connect the battery charger following the manufacturer's
instructions, then charge the battery 3-4 hours.
3. After the battery is charged, inspect the electrolyte level in
each of the cells. Add distilled water as necessary, then
install the battery caps.
4. Clean the outside of the battery and the battery
compartment with a solution of baking soda and water.
Don't allow any of the solution to drip down the vent caps
into the battery cells.
Installation
1. With the seat raised and locked, install the battery into the
riding mower. The battery terminals should face the rear.
2. Install the positive (+) cable onto the battery positive (+)
terminal; then install the negative (-) cable onto the battery
negative (-) terminal, then lower and lock the seat.
Fuse Replacement (electric start models)
The fuse and fuse holder are next to the positive (+)
connector near the battery. The riding mower will not start if
the fuse is blown. To replace the fuse:
65