Checks And Adjustments - Honda HF2315 Original Instruction

WORK
1. MACHINE
1.1 Check of tightness and sharpness of blades
1.2 Blade replacement
1.3 Check the transmission belt
1.4 Transmission belt replacement
1.5 Check the blade drive belt
1.6 Blade drive belt replacement
1.7 Check the belt connecting blades
1.8 Replacement of belt connecting blades
1.9 Check and adjustment of brake
1.10 Check and adjustment of drive
1.11 Check engagement and brake of blade
1.12 Check all fastenings for tight fitting
1.13 General lubrication 2) 3)
1.14 Check the battery level
1.15 Battery charge
2. ENGINE
2.1 Check oil level 1)
2.2 Engine oil change 4)
2.3 Oil filter replacement 4)
2.4 Check 1) and cleaning of air filter
2.5 Air filter replacement 6)
2.6 Check fuel filter 2)
2.7 Fuel filter replacement 2)
2.8 Check and cleaning of spark plug points
2.9 Replacement of spark plug
6.2.2 Rear axle
This is a sealed single unit which does not require maintenance. It
is permanently lubricated and this lubricant does not need changing
or topping up.
6.2.3 Battery
To ensure long life to the battery, it is es-
sential to keep it carefully maintained.
The battery on your machine must be
charged before using for the first time
( 3.4).
During periods when it is not used,
the charge level can be kept con-
stant by using the maintenance
battery charger supplied. For this
purpose the machine is supplied
with a connector (1) to be con-
nected to the corresponding bat-
tery charger connector.
IMPORTANT
No device other than the battery charger is to be
connected to this connector.
IMPORTANT
The charge must be maintained with the battery
charger, following the instructions given in the instruction booklet.
Other recharging systems may definitively damage the battery.
A low battery must be recharged as soon as possible. Otherwise,
irreparable damage could be done to the batteryʼs elements.
EN 16
2)
2)
2)
2)
2)
2)
5) 6)
HOURS DONE
(DATE OR N° OF HOURS)
25
100
25
–
25
–
25
–
10
10
10
25
25
25
100
–
100
100
50
300
100
300
100
300
Periodically check the electrolyte level, which must be between the
MIN and MAX marks on the battery. When topping off, use ONLY dis-
tilled water for batteries.

6.3 CHECKS AND ADJUSTMENTS

6.3.1 Dismantling, sharpening and balancing blades
Blades that are badly sharpened tear at the grass, reduce collection
and make the lawn turn yellow.
IMPORTANT
deck that is equipped with a quick release system that makes their
removal from the machine easy.
a) Removing the cutting deck
HF2315◊••
After moving the cutting height
lever to position «1», loosen the
engagement cable adjuster (1),
pull it out and release the spring
(2).
Free the blades belt (6) from
the clutch pulley (7).
Release the two cotter pins (8)
which hold the two rods (9) onto
the frame.
1)
Check each time used.
2) Contact your Dealer.
3)
General lubrication should also be
carried out whenever the machine
is to be left unused for a long peri-
od.
4)
Operation to be performed also af-
ter the first 20 hours of operation.
5)
Carry out maintenance of the air fil-
ter more frequently in the case of
use on dusty ground.
6)
Replace the paper element only.
When accessing the blades, remove the cutting