Adjustments - Honda HARMONY H1011R Owner's Manual

MAINTENANCE 81 ADJUSTMENTS
Front Wheels
Removal
1. Place the riding mower on a flat, level surface and place the
parking brake ON. Block the rear wheels securely.
2. Lift and securely support the
front end of the riding
mower. Remove the dust
cap, then use circlip pliers
to remove and discard the
old circlip. Remove the flat
washer and wheel.
Installation
1. Apply grease to the axle shaft and inside the wheel hub.
Install the wheel back onto the axle.
2. Install a new circlip. Do not
use the old circlip.
Circlips have a round side
and a flat side. Install the
new circlip with the flat
side out, being careful not
:
to expand the clip too far.
Install the dust cap.
/
Rear Wheel
Removal
1. Block the front wheels securely. Lift and securely support
the rear end of the riding mower. Remove the dust cap,
then use circlip pliers to remove and discard the old circlip.
2. Remove the flat washer, then rotate the wheel, so the
square key on the axle is upright and won't fall off when you
remove the wheel.
3. Carefully pull the wheel and key straight off the axle.
4. Be sure to remove the square key from the axle, otherwise,
it can be difficult to get the wheel back on the axle properly.
69