Seat; Adjustments - Honda HARMONY H1011R Owner's Manual

MAINTENANCE & ADJUSTMENTS
Seat
To access the battery compartment or to adjust the seat
position, you must raise and lock the seat.
Raising and Locking the Seat
1. On the left side of the riding mower, just below the seat
cushion, there is a spring loaded, U-shaped pin used to lock
the seat in either a raised or lowered position. Pull the pin
outward and away from the seat, then raise the seat up.
2. With the seat in the fully
raised position, allow the
pin to slide back toward the
seat bracket to lock it in the
up position.
3. Verify the seat is locked in
the upright position by
pressing down on the seat.
Adjusting the Seat Position
1. Locate and loosen (don't
remove) the four hex bolts
used to attach the seat to
the seat bracket.
2. Move the seat back and forth to obtain the desired position.
3. Securely tighten the four hex bolts, then lower and lock the
seat.
Lowering and Locking the Seat
1. To lower the seat, slightly move the seat upward, to take
pressure off the locking pin.
2. While grasping the seat with one hand, use your other hand
to pull the locking pin away from the seat bracket.
3. Lower the seat all the way down, then release the locking
pin, so it locks into the hole on the side of the seat bracket.
Verify that the seat is locked down by trying to lift the seat.
53