Table of Contents
Advertisement
A+ SERVER 2022TG-HTRF/HIBQRF User's Manual
6-4
Air Guides
The air guides concentrate and maximize air fl ow in the chassis. These air guides
do not require screws to set up, but rather attaches to the serverboard by two tabs
on the air guides. The SC827 chassis requires four identical air guides, one in each
motherboard drawer. Air guides vary depending upon the motherboard used. See
the illustrations below.
Installing an Air Guide
1.
Confi rm that all four fans are in place and are working properly
2.
Place the fi rst air guide into the motherboard drawer. It attaches behind the
system fans and attaches by two tabs over the top of the motherboard and its
components.
3.
Repeat the procedure for the remaining three motherboard drawers.
6-5
Checking the Airfl ow
Checking Airfl ow
1.
Make sure there are no objects to obstruct airfl ow in and out of the server. In
addition, if you are using a front bezel, make sure the bezel's fi lter is replaced
periodically.
2.
Do not operate the server without drives or drive trays in the drive bays. Use
only recommended server parts.
3.
Make sure no wires or foreign objects obstruct airfl ow through the chassis.
Pull all excess cabling out of the airfl ow path or use shorter cables.
4.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons.
Installation Complete
In most cases, the chassis power supply and fans are pre-installed. If you need
to install fans or power supplies, continue to the Systems Fan and Power Supply
sections of this chapter. If the chassis will be installed into a rack, continue to the
next chapter for rack installation instructions.
6-4
Advertisement
Table of Contents
