NordicTrack TRL625 User Manual page 8

8. Position the Seat Carriage (6) as shown. Insert the
Seat Frame Cover (84) into the slot in the Seat
Frame (7). The beveled end of the Seat Frame
Cover should be flush with the end of the Seat
Frame. Attach a Seat Stop (77) and the Seat Frame
Cover to the Seat Frame with an M4 x 16mm Screw
(64).
Push the Seat Frame Cap (13) into the end of the
Seat Frame (7).
9. Identify the Left Pedal (69) (there is an "L" on the
Left Pedal for identification). Using an adjustable
wrench, firmly tighten the Left Pedal counterclock-
wise into the Left Crank Arm (51). Tighten the Right
Pedal (not shown) clockwise into the Right Crank
Arm (not shown). Tighten both Pedals as firmly
as possible. Important: After using the recum-
bent cycle for one week, retighten the Pedals.
For best performance, the Pedals must be kept
properly tightened.
Adjust the Left Pedal Strap (21) to the desired posi-
tion, and press the end of the Strap onto the tab on
the Left Pedal (69). Adjust the Right Pedal Strap
(not shown) in the same way.
10. Make sure that all parts are tightened before you use the recumbent cycle. Place a mat beneath the
recumbent cycle to protect the floor.
8
9
21
Tab
69
8
6
64
77
7
Slot
84
51
13