CYBEX Pro+ Owner's Service Manual page 82

Service
Page 7-21
o
o
A5~~te ~
=
0 ... GREEN LEO
~
O
MotorRela Y Kl
(lit only during drive
motor operation)
I
P2 DiSpl?y
Ca~le
P1
I
DT6 RED LEO
MOIOl'
Control
-0
(Brighler as speed
is increased)
DT11 RED LED
Elevation Dovm Signal
(litwhen .. key
is depressed)
DT13 RED LED
I
Elevation Up
Signal (Ut
when" key
is depressed) .
DT15GREENLEDD'
Of
VAC Incoming
t(~~~~\
Brush c:::::JMotor
O Sense RedA1
Yellow
BW
SERIOUS INJURY COULD OCCUR
IF THESE PRECAUTIONS
ARE NOT OBSERVED
High voltage is present under
this shield. This shield should
only be removed by a qualified
service technician.
Keep wet items away from
inside parts of the treadmill.
High voltage may still be
present even if the treadmill
is unplugged.
OD
Speed
Sensor
Cable
\
DT5 GREEN LED
+9V DC Display
Voltage (Always iii)
Clips
(3)-+---~O
Lower
Board-..
Shield
Figure 19
Figure 18
E. Refer to the lower board shield to
confirm the locations for
the connectors and check to see
that all of the cables are connected
firmly. See Figure 19.
F.
Place the lower board shield in
position and push the clips down.
NOTE: The clips will snap in. See
Figure 19.
A. Lower the motor cover center into
position. See Figure 2.
B. Using a Phillips head screwdriver,
tighten the three screws on each
side. NOTE: Be sure the screws
are catching the center motor'
cover's holes.
Cybex Pro+ Treadmill Owner's & Service Manual
Tie Cables Away _
from Fan
NOTE: The ferrite
is for
internationally
installed motors.
A. Follow the Speed C?llibration procedure located in this chapter (required).
B. If you replaced the motor follow the IR Compensation procedure located in this chapter.
C. If you loosened the tension on the running belt (step 8A) follow the Tension and Center the
Belt procedure located in the Preventive Maintenance chapter.
20. Secure the motor cover.
21. Perform the appropriate
procedures.
• •
••
•
'
.•
•
•
• •
• •
• • ••
•
• •
•
•
• •
•
••
•
• •
•
•
•
•
• •
•
• •
•
•
- e'
e·
••
• •
•