Removal/Installation Of Cassette Compartment - Sony DNW-7 Maintenance Manual

1-7. Removal/Installation of Cassette Compartment

1-7. Removal/Installation of Cassette
Compartment
m
. Be sure to turn off the power, then pull out the power
cord and/or battery before performing the following
procedure. If not, damage to internal circuit may result.
. The cassette compartment can be removed even if it
comes up or goes down.
Removal
1. Remove the front lid and outside panel.
(Refer to section 1-6.)
2. Remove the three screws, hold the position of the
cassette compartment shown in the figure, and remove
it in the direction indicated by the arrow.
(Omit the illustration of the frame)
Screws
( M 1.4 x 3.5 )
Cassette compartment
1-14
Screws
( M 1.4 x 3.5 )
Mechanical deck assembly
Installation
1. Adjust the position of the joint arm so that the clear-
ance between the white roller's outer circumference of
a joint arm and the end face of the mechanical deck
assembly is 0.5 mm.
White roller
0.5 mm
2. Raise the white lock roller of the cassette compartment
so that it comes up.
White lock roller
Joint arm
DNW-7/90/90WS