Cassette Compartment Aseembly Removal And Installation - Sony HDW-700A Maintenance Manual

Removal Without the Tool
1. Insert a screwdriver having a small tip into the panel
hole on the top of the board, move the tool in the
direction of the arrow, and disconnect the connector
connected to the mother board.
Screwdriver, etc.
Panel hole
2. Holding the pull ring in front of the board, remove the
board from the unit
Installation
1. Insert the board according to the board guide rails at
the top and bottom of the unit.
2. Hold the top and bottom of the board firmly, and insert
the board connector into the mother board.
HDW-700AE MMP1
2-5. Cassette Compartment Aseembly
Removal and Installation
m
. Turn off the power before removing or installing the
cassette compartment.
. The cassette compartment can be removed in the raised
or lowered status.
Removal
1. Remove the front lid and the outside panel.
(Refer to Section 2-3.)
2. Remove the three screws, hold the cassette compart-
ment as shown, and remove it in the arrow.
* The frame of the unit is not shown in the figure.
M1.4 x 2.5
Pull ring
Mechanism deck
assembly
2-4. Plug-in Board Removal and Installation

2-5. Cassette Compartment Aseembly Removal and Installation

M1.4 x 2.5
Cassette compartment assembly
M1.4 x 2.5
2-11