Sony DNW-7 Maintenance Manual page 51

Viewfinder screen (Factory default setting)
** VF SETTING **
ZEBRA 1 DETECT : 0
ZEBRA 1 APT : 0
ZEBRA 2 DETECT : 0
ZEBRA SELECT : 1
VF VDTL LEVEL : 0
* LEVEL 1 *
DETAIL LEVEL : 0
V DTL LEVEL : 0
APERTURE LEVEL : 0
KNEE APERTURE : 0
V DTL BLK CLIP : 0
DTL BLK CLIP : 0
LEVEL DEPEND. : MIN
CRISPENING : 4
H DTL FREQ. : 4
* LEVEL 2 *
SUPPRESS LEVEL : MIN
X : 0
Y : 0
dX : 0
dY : 0
SKIN TONE DTL : OFF
SKIN TONE IND. : OFF
SKIN TONE DET. : OFF
DNW-7/90/90WS
Description
........... Sets the center level of the zebra 1 pattern.
........... Sets the width of the zebra 1 pattern.
........... Sets the lower-limit level of the zebra 2 pattern. The upper-limit level is the
white clip level.
........... Sets the zebra patterns ZEBRA1/ZEBRA2/both.
n
The zebra detection level can be measured on waveform monitor when the
TEST OUT is set to any position other than ENC and the zebra switch on VF is
set to ON.
........... Set the level of the V detail signal of the video outputting to the viewfinder.
........... Sets the total level of the detail signal.
........... Sets the level of the V detail. The H/V ratio is adjusted using this item.
........... Sets the high-frequency correction level.
........... Sets the detail level after the gamma correction.
........... Sets the clipping level in the negative (–) direction of the V detail.
........... Sets the clipping level in the negative (–) direction of the H detail.
........... Sets the level of the skin tone detail amount in the low level.
........... Sets the crispening level of the detail signal.
........... Sets frequency (amount) of the H detail.
........... Sets the skin tone detail range and amount.
X : Component of red
Y : Component of blue
........... Sets whether to activate the skin tone detail function.
n
This item is the same as the "SKIN TONE DTL" item on the "FUNCTION 1/2"
page.
........... Sets whether to display the skin tone detection area.
Disable this item during the color bars output.
The indicator is automatically set to OFF when the POWER switch to OFF.
Sets this item to OFF when the ZEBRA SELECT set to 2.
........... Set the skin tone automatic detection.
3-1. Setup Menu
3-7