Usb Copy; Management Mode; Typical Setup Procedure - Thecus 1U4600 User Manual

Hide thumbs Also See for 1U4600:
Table of Contents

Advertisement

Disk Info
RAID
The 1U4600 will rotate these messages every one-two seconds on the LCD display.

USB Copy

The USB Copy function enables you to copy files stored on USB devices such as USB
disks and digital cameras to the 1U4600 by press button. To use USB copy, follow
the steps below:
1. Plug your USB device into an available USB port on the Front end.
2. In Display Mode, press the Down Button (▼).
3. The LCD will display "USB Copy?"
4. Press Enter (
the front USB port.
5. All of data will be copied into system folder named "USB copy".

Management Mode

During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is " 0000 ". If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item
WAN Setting
LAN Setting
Link Agg. Setting
Change Admin Passwd
Reset to Default
Exit
NOTE

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your 1U4600 for use
on your network. Setting up the 1U4600 typically follows the five steps outlined
below.
For more on how to use the Web Administration Interface, see
Chapter 4:
Web Administration
Current status of disk slot has been installed
Current RAID status.
) and the 1U4600 will start copying USB disks connected to
Description
IP address and netmask of your WAN ports.
IP address and netmask of your LAN ports.
Select Load Balance, 802.3ad or Failover.
Change administrator's password for LCD operation.
Reset system to factory defaults.
Exit Management Mode and return to Display Mode.
You can also change your LCD password using the Web Administration
Interface by navigating to System Management >Utility>
Administrator Password. For more on the Web Administration
Interface, see Chapter 4: System Management.
Interface.
↵)
and an "Enter Password" prompt
20

Advertisement

Table of Contents
loading

Table of Contents