Usb Copy; Typical Setup Procedure; Ment Mode - Thecus N5500 User Manual

Disk Info
RAID
The N5500 will rotate these messages every one-two seconds on the LCD display.

USB Copy

The USB Copy function enables you to copy files stored on USB devices such as USB
disks and digital cameras to the N5500 by press button. To use USB copy, follow the
steps below:
1. Plug your USB device into an available USB port on the Front end.
2. In Display Mode, press the Down Button (▼).
3. The LCD will display "USB Copy?"
4. Press Enter (
front USB port.
5. All of data will be copied into system folder named "USB copy".
Management Mode
During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is " 0000 ". If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item
WAN Setting
LAN Setting
Link Agg. Setting
Change Admin Passwd
Reset to Default
Exit
NOTE

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your N5500 for use
on your network. Setting up the N5500 typically follows the five steps outlined
below.
For more on how to use the Web Administration Interface, see
Chapter 4: Web Administration
Current status of disk slot has been installed
Current RAID status.
↵
) and the N5500 will start copying USB disks connected to the
Description
IP address and netmask of your WAN ports.
IP address and netmask of your LAN ports.
Select Load Balance, 802.3ad or Failover.
Change administrator's password for LCD operation.
Reset system to factory defaults.
Exit Management Mode and return to Display Mode.
You can also change your LCD password using the Web Administration
Interface by navigating to System Management >Utility>
Administrator Password. For more on the Web Administration
Interface, see Chapter 4: System Management.
Interface.
↵)
and an "Enter Password" prompt
21