The 1U4500 will rotate these messages every one-two seconds on the LCD
display.
USB Copy
The USB Copy function enables you to copy files stored on USB devices such as
USB disks and digital cameras to the 1U4500 with a press of a button. To use
USB copy, follow the steps below:
1. Plug your USB device into an available USB port on the Front Panel.
2. In Display Mode, press the Down Button (▼).
3. The LCD will display "USB Copy?"
4. Press Enter (
the front USB port.
5. All of data will be copied into system folder named "USBcopy".
Management Mode
During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
prompt will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is "0000". If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item
WAN Setting
LAN Setting
Link Agg. Setting
Change Admin Passwd
Reset to Default
Exit
NOTE
Typical Setup Procedure
From the Web Administration Interface, you can begin to setup your 1U4500 for
use on your network. Setting up the 1U4500 typically follows the five steps
outlined below.
For more on how to use the Web Administration Interface, see Chapter 4:
System Management >
↵
) and the 1U4500 will start copying USB disks connected to
Description
IP address and netmask of your WAN ports.
IP address and netmask of your LAN ports.
Select Load Balance or Failover.
Change administrator's password for LCD operation.
Reset system to factory defaults.
Exit Management Mode and return to Display Mode.
You can also change your LCD password using the Web Administration
Interface by navigating to System > Administrator Password. For
more on the Web Administration Interface, see Chapter 4: System
Management.
Web Administration
↵)
and an "Enter Password"
Interface.
16