Stopping the Engine
1.
Push the command button on the transmitter for
1 second or less, then push the stop button within 2
seconds.
2.
The transmitter emits a short beep and sends a
signal to stop the engine. When the engine stops,
the OFF indicator is shown on the display.
COMMAND
BUTTON
STOP
BUTTON
16
NOTE
•
When the RF signal from the
transmitter does not carry to
the receiver, the transmitter
emits three short buzzer
sounds but no indicator is
shown on the display.
•
The engine cannot be stopped
with the transmitter when it was
started using the ignition key.
•
In some cases the remote transmission range can be
ENGINE-OFF
longer than the reception range. Therefore the engine
INDICATOR
can be started/stopped, and the remote status may
not be displayed.
7336070T
5718100S