Table of Contents
Advertisement
1.0 INSTRUCTION
1.1 Safety Instructions
DO NOT INSTALL YOUR RECEIVER:
In a closed or poorly ventilated cabinet; directly on top of or under any another
n
equipment; on a surface which might obstruct the ventilation slots
DO NOT EXPOSE THE RECEIVER OR ITS ACCESSORIES:
To direct sunlight or near any other equipment that generates heat; to rain or intense
n
moisture; to intense vibration and to any shock which may cause permanent damage to
your receiver or to any magnetic objects, such as loudspeakers, transformers, etc.
Do not use a damaged power cord. It may cause a fire or an electrical shock. Do not
n
touch a power cord with wet hands. It may cause an electric shock.
Never open the cover. It is dangerous to touch the inside of the receiver due to high
n
voltage currents and possible electrical hazards. Your warranty will be void if the receiver
has been opened.
When the receiver is not used for a long period of time, you should unplug the power
n
cord from the wall socket.
Do not use alcohol or ammonia based liquids to clean the receiver. If you wish, you
n
may clean your receiver with a soft lint-free cloth slightly made damp with a mild soap
solution, only after disconnecting from the mains voltage supply. Make sure no foreign
objects fall through the ventilation slots because this could cause fire or an electric shock.
Do not place any objects on top of the receiver because this might prevent proper cooling
n
of the components inside.
Safety Precautions
Do not open the receiver cover, as you will be exposed to a shock hazard. It will also void
n
your warranty. Refer all maintenance or servicing to suitably qualified personnel
When you are connecting the cables, be sure that the receiver is disconnected from the
n
mains supply voltage. Wait a few seconds after switching off the receiver before you move
the receiver or disconnect any equipment.
It is a necessity that you only use an approved extension and compatible wiring that
n
is suitable for the electrical power consumption of the installed equipment. Please
ensure that the electrical power supply corresponds with the voltage on the electrical
identification plate at the back of the receiver.
If the receiver does not operate normal even after strictly following the instructions of this user
manual, it is recommended to consult your dealer.
2
PART 1 • English
Advertisement
Table of Contents
