Preparing The Handset; Inserting The Supplied Batteries And Closing The Battery Cover; Connecting The Charging Cradle And Charging The Batteries - Siemens Gigaset 5675 Quick Manual

6
1

Inserting the supplied batteries and closing the battery cover

>
First, align the notches on the side
of the battery cover with the
protrusions on the inside of the
housing.
>
Then press the cover until it clicks
into place.
>
The display is protected by a plastic film. Please remove the protective film!
2

Connecting the charging cradle and charging the batteries

B

Preparing the handset

>
Observe the
sequence (A, B).
A
>
Check the polarity when inserting the batteries
(see symbols in or on the battery compart-
ment).
>
Only use the recommended rechargeable bat-
teries.
Once the batteries have been inserted, the hand-
set turns on automatically.
>
Place the handset in the charging cradle and
wait until the batteries are fully charged.
>
Do not put the handset back in the
charging cradle until the batteries are
fully discharged through use.
>
After the first battery charge and
discharge, replace your handset in the
charging cradle after every call.
>
The battery charging status is displayed
in the idle display: = e V U (flat to
full).