Preparing The Handset - Siemens Gigaset S675 IP Installation Manual

Preparing the handset

1
Inserting the supplied batteries and closing the battery cover
>
First, align the notches on the
side of the battery cover with
the protrusions on the inside of
the housing.
>
Then press the cover until it
snaps into place.
>
The display is protected by a plastic film. Please remove this protective film.
2
Connecting the charging cradle and charging the batteries
B
A
>
>
Once the batteries have been inserted, the handset
switches on automatically.
>
Observe the
sequence
(A then B)!
Check the polarity when inserting the batteries
(see symbols in or on the battery compartment).
Only use the recommended rechargeable
batteries.
>
Place the handset in the charging cradle and
wait until the batteries are fully charged.
>
Do not put the handset back in the
charging cradle until the batteries are
fully discharged through use.
>
After the first battery charge and dis-
charge, you may place your handset in the
charging cradle after every call.
>
The battery charging status is displayed
in the idle display: = e V U
(empty to full).
7