Pnp/Pci Configurations - ECS KM400-M2 Manual

IRQs Activity Monitoring
This screen enables you to set IRQs that will resume the system from a power saving mode.
Primary INTR
IRQ3 (COM2)
IRQ4 (COM1)
IRQ5 (LPT2)
IRQ6 (Floppy Disk)
IRQ7 (LPT 1)
IRQ8 (RTC Alarm)
IRQ9 (IRQ2 Redir)
IRQ10 (Reserved)
IRQ11 (Reserved)
IRQ12 (PS/2 Mouse)
IRQ13 (Coprocessor)
IRQ14 (Hard Disk)
IRQ15 (Reserved)
: Move
F5:Previous Values
Set any IRQ to Enabled to allow activity at the IRQ to wake up the system from a power
saving mode.
Press <Esc> to return to the Power Management Setup page.

PNP/PCI Configurations

These options configure how PnP (Plug and Play) and PCI expansion cards operate in your
system. Both the ISA and PCI buses on the motherboard use system IRQs (Interrupt
ReQuests) and DMAs (Direct Memory Access). You must set up the IRQ and DMA assign-
ments correctly through the PnP/PCI Configurations Setup utility for the motherboard to
work properly. Selecting PnP/PCI Configurations on the main program screen displays this
menu:
Reset Configuration Data
Resources Controlled by
x
IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For USB
: Move
F5:Previous Values
Reset Configuration Data (Disabled)
If you enable this item and restart the system, any Plug and Play configuration data stored
in the BIOS Setup is cleared from memory.
(Press Enter)
Phoenix-AwardBIOS CMOS Setup Utility
IRQs Activity Monitoring
[ON]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F6:Fail-Safe Defaults
Phoenix-AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
[Disabled]
[Auto (ESCD)]
Press Enter
[Disabled]
[Enabled]
Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F6:Fail-Safe Defaults
Using BIOS
Item Help
Menu Level
F7:Optimized Defaults
Item Help
Menu Level
Default is Disabled. Select
Enabled to reset Extended
System Configuration Data
ESCD) when you exit Setup
if you have installed a new
add-on and the system
reconfiguration has caused
such a serious conflict that
the OS cannot boot
F7:Optimized Defaults
39