ECS KM400-M2 Manual page 44

38
IRQ/Event Activity Detect (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
VGA (OFF)
When set to On, the system power will resume the system from a power saving mode if
there is any VGA activity.
LPT & COM (LPT/COM)
When this item is enabled, the system will restart the power-saving timeout counters when
any activity is detected on the serial ports, or the parallel port.
HDD & FDD (ON)
When this item is enabled, the system will restart the power-saving timeout counters when
any activity is detected on the hard disk drive or the floppy diskette drive.
PCI Master (OFF)
When set to Off, any PCI device set as the Master will not power on the system.
PowerOn by PCI Card (Enabled)
Use this item to enable PCI activity to wakeup the system from a power saving mode.
Modem Ring Resume (Disabled)
Use this item to enable modem activity to wakeup the system from a power saving mode.
RTC Alarm Resume (Disabled)
When set to Enabled, additional fields become available and you can set the date (day of the
month), hour, minute and second to turn on your system. When set to 0 (zero) for the day
of the month, the alarm will power on your system every day at the specified time.
Phoenix-AwardBIOS CMOS Setup Utility
IRQ/Event Activity Detect
VGA
LPT & COM
HDD & FDD
PCI Master
PowerOn by PCI Card
Modem Ring Resume
RTC Alarm Resume
X
Date (of Month)
X
Resume Time (hh:mm:ss)
IRQs Activity Monitoring
: Move Enter: Select
F5:Previous Values
[OFF]
[LPT/COM]
[ON]
[OFF]
[Enabled]
[Disabled]
[Disabled]
0
0 : 0 : 0
[Press Enter]
+/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F6:Fail-Safe Defaults F7:Optimized Defaults
Using BIOS
Item Help
Menu Level
When select Pass-
word, please press
ENTER key to change
Password Max 8
numbers.