Power Management Setup - ECS KN1 Extreme Manual

3.3-5 Power Management Setup

This option lets you control system power management. The system has
various power-saving modes including powering down the hard disk, turning
off the video, suspending to RAM, and software power down that allows
the system to be automatically resumed by certain events.
Phoenix-AwardBIOS CMOS Setup Utility

Power Management Setup

ACPI Suspend Type [S3(STR)]
Video Off Method [DPMS Support]
HDD Power Down [Disabled]
HDD Down In Suspend [Disabled]
Soft-Off by PBTN [Instant-Off]
Power On By Button [Disabled]
Power On By Mouse [Disabled]
Power On By Keyboard [Disabled]
x KB Power ON Password Enter
x
Hot Key Power ON Ctrl-F1
PWRON After PWR-Fail [Off]
Resume By PCI PME [Enabled]
Resume By Ring [Disabled]
Power-On by Alarm [Disabled]
x Day of Month Alarm 0
x Time (hh:mm:ss) Alarm 0 : 0 : 0
AMD K8 Cool'n'Quiet control [Auto]
Hammer Fid control [StartUp]
: Move Enter: Select +/-/PU/PD:Value
F5:Previous Values F6:Performance Defaults
ACPI Suspend Type [S3(STR)]
Use this item to define how your system suspends. In the default, S3 (STR), the
suspend mode is a suspend to RAM, i.e., the system shuts down with the exception
of a refresh current to the system memory. If you select S1 (POS), the suspend
mode is equivalent to a software power down.
Video Off Method (DPMS Support)
This selection will cause the system to turn off the vertical and horizontal synchroni-
zation ports and write blanks to the video buffer.
Item Help
HDD Power Down [Disabled]
Menu Level
The IDE hard drive will spin down if it is not accessed within a specified length of
time.
HDD Down In Suspend [Disabled]
This item enable or disable whether the IDE hard drive to be down in suspend mode.
Soft-Off by PBTN (Instant-Off)
Under ACPI (Advanced Configuration and Power management Interface) you can
create a software power down. In a software power down, the system can be resumed
by Wake Up Alarms. This item lets you install a software power down that is controlled
by the power button on your system. If the item is set to Instant-Off, then the power
button causes a software power down. If the item is set to Delay 4 Sec. then you have
to hold the power button down for four seconds to cause a software power down.
Power On By Button (Enabled)
Enable or disable the function of waking up the system by the power-on button.
F10:Save ESC:Exit F1: General Help
F7:Optimized Defaults
Power On By Mouse (Enabled)
Enable or disable the function of waking up the system by the mouse activity.
3-13