B. Arming the system in the INSTANT mode (without
an entry delay): Pressing the AUX button immediately
after arming, during exit delay, causes the system to
be armed without an entry delay. This means that
entering the protected premises via any zone will
trigger an immediate alarm. You and other holders of
keyfob transmitters will have no problem, because you
can disarm the system before entering by pressing the
DISARM (
) button on your transmitter before entry.
C. Getting status information: Upon pressing the AUX
button
on
your
announces the system status over the loudspeaker.
Disarming by a keyfob whose battery voltage is low
If you try to disarm the system with a keyfob whose battery
voltage is low, a protest beep will be heard for 15 seconds
(if this beep is enabled by the installer). During this period
you should press again the disarm button of the keyfob or
control panel (for the control panel, user code is required)
to disarm the system. If you perform this action during the
15 seconds period, the Low Bat message will be stored in
the event log.
PowerMax+ control panel
Note regarding the Mute Speaker button
The Mute Speaker button is active only if the "Set Voice Option" function is enabled ("enable prompts" - see user setting
flow-chart, fig. 8).
6
transmitter,
the
voice
CHIME ON/OFF
MUTE SPEAKER
EMERGENCY
(Hold for 2 sec.)
Figure 4. Controls and Indicators
If the disarm button is not pressed again during the 15
seconds period, perform either of the following actions:
A. Press AWAY twice to arm the system, otherwise the
system will not be armed and an acknowledgement
(from the user that he knows about the Low Bat) will not
be stored in the event log.
B. Press AWAY and then press disarm button, to ack-
knowledge, otherwise the acknowledgement will not be
stored in the event log.
1.7 Voice Announcements
The pre-recorded voice announcements respond to your
module
commands by announcing what the system is doing and by
prompting you to perform certain actions. They also
announce alarms, troubles and identify the source of each
event.
The pre-recorded plain language announcements made by
the voice module are quite clear and self explanatory.
Therefore, the spoken text was omitted in the following
sections of this guide and focused attention on visual
display and sounder beeps. This way the user guidance is
brief and concise.
ARM
INDICATOR
TROUBLE
INDICATOR
CHIME
INDICATOR
POWER
INDICATOR
RECORD MESSAGE
VOLUME UP /
LIGHT BRIGHT
PLAY MESSAGE
VOLUME DOWN /
LIGHT DIM
NO ENTRY DELAY
EVENT LOG
Press both buttons
for panic alarm
LCD
WINDOW
"SHOW / OK"
"NEXT"
BUTTON
BUTTON
LIGHT ON
FIRE
(Hold for 2 sec.)
ARMING
"AWAY"
LIGHT OFF
ARMING "HOME"
LIGHT CONTROL
DISARMING
TESTING
RETRACK
DE5467U
Need help?
Do you have a question about the powermax+ and is the answer not in the manual?