Pin Assignment Of Internal Ports - Fujitsu D1567 Technical Manual

Pin assignment of internal ports

The pin assignment of some internal connections is shown in English in the following.
i
Some of the following connectors may be optional!
Front panel
Watch the poling of the LEDs. The positive pole
of the connection cables is often indicated with a
coloured wire.
Connection
Reset
Power On/Off
HD LED
SCSI Activity Attention: Do not connect to the LED connections of an SCSI controller! This
Input connection is intended for a cable with a 4-pin connector. An SCSI controller
reports activity (low-active) via this cable.
Message LED
Power On LED Indicates the system state APM or ACPI together with the Sleep LED (see
chapter entitled "APM and ACPI system status, energy-saving modes").
Speaker
Power On LED II
Pin
1
2
3
A26361-D1567-Z121-1-6319
Pin assignment of internal ports
Power On/Off
Reset
1) The same interface
2) 2pin or 3pin connector possible
Note
0,5 W at 8 Ohm
Signal
Power On LED (Anode)
Power On LED (Anode)
Power On LED (Cathode)
Message LED
Power On
LED 2)
HD-LED
1)
SCSI LED Input
1 3
1
2
Speaker
English - 11