Honda 08B15-S9V-100 Installation Instructions Manual page 6

14. Fit the DIN bezel around the display module
pocket. Set the heater control unit on the display
module pocket, and reinstall the left and right
vehicle brackets using the two self-tapping screws
removed in step 9. Attach the display module to
brackets with three self-tapping screws supplied
with the XM radio attachment kit.
SELF-
LEFT
TAPPING
VEHICLE
SCREW
BRACKET
(Reuse.)
SELF-TAPPING
SCREWS
(Supplied with
XM radio
attachment
kit)
DISPLAY
MODULE
POCKET
Routing the XM Radio Harness
15. Remove the driver's seat front cover (four clips).
DRIVER'S
SEAT
DRIVER'S
SEAT FRONT
COVER
6 of 14
HEATER
CONTROL
UNIT
RIGHT
VEHICLE
BRACKET
SELF-
TAPPING
SCREW
(Reuse.)
DIN
SELF-TAPPING
BEZEL
SCREWS
(Supplied with
XM radio
attachment kit)
3121051M
CLIPS (4)
16. Remove the driver's seat rear cover (four clips).
Take care not to damage the clips.
DRIVER'S SEAT
REAR COVER
17. Remove the drivers seat (four bolts). Move the
driver seat out of the way.
AII 25886 (0308)
DRIVER'S SEAT
CLIPS (4)
DRIVER'S SEAT
BOLTS (4)
© 2003 American Honda Motor Co., Inc - All Rights Reserved.