Honda 08B15-S9V-100 Installation Instructions Manual page 11

37. Remove the fuel lid door opener lever, then
remove the left front door sill trim (three clips and
two retaining tabs).
RETAINING
TAB
FUEL LID DOOR
OPENER LEVER
CLIPS (2)
38. Remove the weatherstrip from the left kick panel.
Remove the upper clip from the left kick panel,
then pull the left kick panel out toward you to
release the retaining clip.
WEATHERSTRIP
LEFT KICK
PANEL
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
LEFT
FRONT
DOOR SILL
TRIM
CLIP
CLIP
CLIP
AII 25886 (0308)
39. Get two EPT sealers. Using scissors, cut two
EPT sealers into six pieces. Wrap the them
around the antenna unit cable at the
measurements shown.
60 mm
60 mm
60 mm
60 mm
EPT SEALER
40. Using isopropyl alcohol on a shop towel, clean the
bottom of the antenna unit. Remove the backing
from the 60 x 60 mm double-sided adhesive tape,
and attach it to the bottom of the antenna unit.
ANTENNA
UNIT
ADHESIVE
BACKING
(Remove.)
ANTENNA
PLATE
ADHESIVE
BACKING
(Remove.)
Clean with
isopropyl alcohol.
41. Using isopropyl alcohol on a shop towel, clean the
areas where the antenna unit and the antenna
plate will attach.
42. Remove the adhesive backing from the antenna
unit and the antenna plate, and attach them to the
dashboard in the area shown.
ANTENNA
UNIT
60 mm
200 mm
ADHESIVE
BACKING
(Remove.)
60 x 60 mm
DOUBLE-SIDED
ADHESIVE TAPE
Cut.
ANTENNA UNIT
CABLE
DASHBOARD
11 of 14