Honda 08B15-S9V-100 Installation Instructions Manual page 9

28. Plug the XM radio harness 20-pin connector and
sub antenna cable into the audio unit, and
carefully slide the audio unit into the dashboard.
Reinstall the four audio unit screws.
SUBANTENNA
CABLE
29. Secure the XM radio harness, subantenna cables,
and display module cable to the vehicle pipe with
two wire ties.
VEHICLE
PIPE
WIRE
TIES
DISPLAY
MODULE
CABLE
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
XM RADIO
HARNESS 20-PIN
CONNECTOR
AUDIO
UNIT
SCREW (4)
(reused)
DISPLAY MODULE
CABLE
SUBANTENNA
CABLE
XM RADIO
HARNESS
30. Continue routing cables through the center
console and toward the rear of the vehicle. Using
scissors, cut one cushion tape in half. Clean the
vehicle frame with isopropyl alcohol, and attach
half of the cushion tape to the vehicle frame in the
area shown.
CUSHION
TAPE
CUSHION
TAPE
31. Secure the XM radio harness and subantenna
cables with one wire tie, but don't tighten the wire
tie at this time.
CUSHION
TAPE
VEHICLE
HARNESS
WIRE TIE
DISPLAY MODULE
CABLE
32. Attach the remaining half of the cushion tape to
the vehicle frame in the area shown.
AII 25886 (0308)
VEHICLE FRAME
(Clean with
isopropyl alcohol.)
HARNESS
XM RADIO
HARNESS
SUBANTENNA
CABLE
DISPLAY MODULE
CABLE
Cut.
VEHICLE FRAME
(Clean with
isopropyl alcohol.)
SUBANTENNA
CABLE
VEHICLE
2N27130M
XM RADIO
HARNESS
9 of 14