Arming Mode
(AUTOMATIC MANUAL)
1
ON
LOCK
2
3
4
5
6
7
© 2002 American Honda Motor Co., Inc. - All Rights Reserved.
This section explains how to change the arming mode from AUTOMATIC to MANUAL.
Turn the ignition key from the ON (II) position to the LOCK (0) position.
Remove the key from the ignition switch.
Open a door and close it. (The EXIT delay starts.)
NOTE: Steps 3 thru 7 must be completed within 5 seconds.
Insert the ignition key.
Remove the ignition key from the ignition switch. (All the way out)
Insert the ignition key.
Remove the ignition key from the ignition switch. (All the way out)
Insert the ignition key.
Observe that the system beeps
AUTOMATIC MODE
twice.
MANUAL MODE
System Controls
The switching procedure is
The result
Not completed
No beep
Completed
Beep twice
7