Follett 7CI100A Installation, Operation And Service Manual page 9

Installation
(continued)
3. Remove four plastic, thread-protecting plugs from bottom of
dispenser.
4. Attach dispenser to base stand with supplied hardware (Fig. 5).
NOTICE!
If installing optional Drip Tray Drain Kit, refer to instructions
included with the Drip Tray Drain Kit.
5. Connect water line. Recommended routing (Fig. 6) allows easy access
to water for cleaning and sanitizing procedure.
6. If installing the optional internal water fi lter*, please see
Internal Water Filter Installation on page 10
If not, proceed to step 7.
* If your dispenser has the internal water fi lter option, the water fi lter must be
installed for the dispenser to operate. Because internal components will need to
be accessed for both procedures, Follett recommends installing the water fi lter
just prior to initial sanitizing.
7. Connect power supply.
8. Sanitize the dispenser prior to use (see
on page 13).
–––––––––––––––––––––––––––––––––––––––––––––––––
before proceeding.
Cleaning and Sanitizing
Fig. 5
Fig. 6
Optional
3' (91.4 cm)
Dispenser and Icemaker 7CI100A/7FS100A
X4
Plug
Valve
1/4" MPT
9