Service; Led Indicator Description - Follett 7CI100A Installation, Operation And Service Manual

Cleaning and Sanitizing
Cleaning: User Interface and Exterior Cabinet
1. Press and release maintenance/clean switch so that only "FRESH FILTERED ICE AND WATER" displays
in the user interface to enter Cleaning Mode (and disable dispensing).
2. Plastic parts, including the user interface, can be cleaned with a non-abrasive glass cleaner. Clean
stainless steel panels with stainless steel cleaner.
3. Press and release maintenance/clean switch to put unit back into service.
Service –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

LED Indicator Description

The LED Indicator is located behind the front panel.
Fig. 15
LED Name LED Color
Clean Green
— N/A
PM Red
Drip tray Red
Water leak Red
High amps Red

Service

Red
Maintenance Yellow
Low water Yellow
Time delay Yellow
Sleep cycle Green
Making ice Green
Low bin Green
Power on Green
14 Dispenser and Icemaker 7CI100A/7FS100A
––––––––––––––––––––––––––––––––––––––
(continued)
The dispenser is in Cleaning Mode. Dispenser is disabled to allow for cleaning of front panel.
See Maintenance/Cleaning Mode on page
Not used.
Six-month periodic maintenance required.
Drip tray full.
Internal leak in dispenser.
Auger gearmotor has exceeded 0.55A. The HI amps and Time delay LEDs will illuminate,
the machine will shut down for one hour, the LEDs will turn off, and the machine will resume
normal operation.
8000 hour bushing check (call Follett technical service group at (877) 612-5086 or
+1 (610) 252-7301).
Enter Maintenance Mode by pressing and holding maintenance/clean switch for 5 seconds.
Unit will not make or dispense ice.
Insufficient water supply to machine or no low bin LED upon startup.
Ice production will not resume for at least 15 minutes after a full bin is achieved and a
minimum amount of dispense activity has elapsed.
After a full bin and 10 minutes of non-use, the unit goes into standby and will not produce ice
until either 12 hours has elapsed or ice or water has dispensed.
Gearmotor, compressor, and fan motor energized.
Bin switch closed calling for ice.
Power supplied to unit.
Description
11.