End Of Wash Cycle; Forgot To Add Dish; Change Program; Turning On Appliance - Whirlpool Dishwasher User Manual

Dishwasher
Hide thumbs Also See for Dishwasher:
Table of Contents

Advertisement

Turning On the Appliance
Starting a cycle wash
• Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one (see the section entitled Loading
the Dishwasher).
• Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid).
• Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
• Close the door, press the ON/OFF button, and the ON/OFF light will turn on. Press the program
button to select a desired wash cycle, After 3 seconds, the machine will work.
Change the Program...
Premise:
• A cycle that is underway can only be modified if it has only been running for a short time. Otherwise,
the detergent may have already been released, and the appliance may have already drained the wash
water. If this is the case, the detergent dispenser must be refilled (see the section entitled "Loading the
Detergent").
• When you press the start/reset button more than 3 seconds, you can cancel the running programme
and select other programmes (see the section entitled " Starting a wash cycle...").
• When you select Intensive/Normal/Eco.Programmes, you can select the 3in1 function.
NOTE: If you open the door during a wash cycle, the machine will pause. When you close the door, the
machine will continue working after 10 seconds.
Forgot to Add a Dish?
A forgotten dish can be added at any time before the detergent cup opens.
1. Open the door a little to stop the washing.
2. After the spray arms stop working,you can open the door completely.
3. Load the forgotten dishes.
4. Close the door, the dishwasher will start running again after 10 seconds.
At the End of the Wash Cycle
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop.
Turn off the appliance using the ON/OFF button, shut off the water supply and open the door of the
dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while
they are still hot and more susceptible to breakage. They will also dry better.
• Switch Off the Dishwasher
The program has ended, only if there appears a 0 in the digital display (remaining program time).
1. Switch off the dishwasher by pressing the ON/OFF button.
2. Turn off the water tap!
• Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15
minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this
way they will be cooler and the drying will be improved.
• Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
Basket onto the dishes in the lower one.
WARNING:
It is dangerous to open the door when washing, because the hot water may scald you.
18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents